A  Fujita Cold Air Intake is traditionally longer and in usually extends behind the bumper cover so that it can take in colder air that denser and more concentrated. In addition the intake gets more direct oxygen, the longer plenum achieves higher torque gains as well as impressive horsepower figures. Depending on the complexity of the plenum route, these Cold Air Intake systems may come as a 1 piece or 2 piece intakes. Different diameters, filters, and bends are all key factors of the R&D process of each Cold Air Intake. The in-house Dynojet is the final judge of which intake configuration will make it to production. Air/Fuel ratios are also an important factor in testing the Cold Air Intake, ensuring that safe and near factory levels are maintained in order to not trip any electronic sensors on the vehicle.

A cold air intake is also one of the first upgrades made to a vehicle due to the simplicity of the install.  Usually anybody that can use a wrench can install a cold air intake in a couple hours or so.  With the basic bolt on applications you will see instant results.

Made from 6061 T6 Aluminum Alloy you will be sure to have an cold air intake system built well and with a nice finish.  The carbon plated t-bolt clamps are very strong and reliable too.  This ensures that this cold air intake is meeting or exceeding the specs of SAE you know its quality.  The machined mass sensor fittings are there to ensure that you get the best air/fuel ratios for maximum results and accuracy. The cold air intake has TIG welded brackets with rubber vibrations mounts to dampen vibrations to reduce stress on the system.  The filter is going to be one of the most important aspects of this cold air intake.  It is designed with maximum efficiency without sacrificing filtration.  Your cold air intake will come with this super flow high performance air filter ensuring a clean flow of air to your engine.

• 6061 T6 Aluminum Cold Air Intake Tubing with Polished finish *except special editions
• Reinforced Silicone Hose
• Carbon Plated T-bolt clamps *unless linear clamps are required
• Fujita Super Flow High Performance Filter
• TIG Welded bracket
• Vibration Mounts